Aisle · 14 Premium Parts

Chimney Top — Caps, Covers & Draft

The top of the chimney is the single most cost-effective place to spend money well — a correct cap and a sound chase cover keep water out, and water is what destroys masonry from the inside. TCE leads with alloy and gauge: stainless and copper because they outlast the chimney, with galvanized offered as the honest budget floor and labeled as such. Every cap, cover, and damper here is sized to your flue from a measurement, never a guessed stock fit.

See the parts Book an inspection

On the counter now

No prices are listed — every part is quoted after a fit check confirms the inspection finding it answers. Anchor components open a full page; boxed code parts and accessories are listed here.

Anchor / installed

Copper Chase Cover (Custom-Fabricated)

We fabricate this chase top in solid copper, fully sloped with standing seams and cut to the exact dimensions of your chase, not a stock size. Copper is the only material we'll spec for a chimney that anchors the roofline: it patinas instead of streaking your siding with rust, and a correctly templated cover never needs a second visit. We take the field measurements ourselves before fabrication, because a cover that's approximately right is a cover that eventually leaks.

Material: Solid copperStore fit: Quote-to-fabricate, measured on site

View pageQuote

Anchor / installed

Architectural Multi-Flue Shroud (Decorative)

For a custom home where curb appeal is part of the brief, we build a sheet-metal shroud sized to the chase rather than dropping on a stock cap. Powder-coated steel or copper, corbeled or hip-roofed to match the architecture — we proportion it so it reads correctly from the street, because a capped chimney and a finished chimney are not the same product.

Store fit: Quote-to-fabricate

View pageQuote

Anchor / installed

Integrated Crown-Cap Unit (Drip-Edge Crown + Cap)

When a crown has already cracked, patching the concrete just buys time before it re-cracks. Our stainless top caps every flue on the chimney and overhangs the crown so water sheds clear of the masonry permanently. Before we sell it we inspect whether the crown needs repair underneath first or whether the cap alone resolves the leak — we document the finding rather than assume.

Material: Stainless steelStore fit: Quote-to-fabricate

View pageQuote

Anchor / installed

Powered Draft System (Enervex / Exhausto Inducer + Modulating Control)

This roof-mounted, variable-speed fan uses a sensor control to mechanically draw smoke up a flue that won't draft on its own. We treat it as the last option, not the first: in most cases a height correction, a different cap, or a resized liner fixes the draft fault for less money, so we diagnose before we quote the fan. Where the flue geometry genuinely can't self-draft, we commission this unit to correct the draft, not to mask the underlying defect.

Brand: Enervex / ExhaustoStore fit: Quote-to-install, draft-diagnosed first

View pageQuote

Premium grade

Single-Flue Copper Rain Cap

A single-flue rain cap in solid copper with mesh screening — the corrosion-proof, decorative step up from a rusting stock cap. It's the entry point into copper without custom fabrication: sized to your actual flue tile rather than the nearest off-the-shelf diameter, so homeowners who want the copper look on a standard flue get a correct fit, not an approximation.

Material: Solid copperStore fit: Ships boxed; install offered