Wood-to-Gas Fireplace Conversion in The Colony, TX in DFW | Texas Chimney Experts
Texas Chimney Experts — DFW chimney & fireplace specialists. Free inspection, written quote, no surprise fees.
Wood-to-Gas Fireplace Conversion for The Colony homes — replace your wood-burning fireplace with a clean, on-demand gas appliance. Four conversion paths from $800 (vented log set) to $14,000 (full rebuild). Permit + gas line + appliance + final inspection bundled into one written quote. Texas Chimney Experts handles this work across the Dallas-Fort Worth Metroplex following NFPA 211 standards. Free inspection, written quote, no surprise fees.
What’s actually involved
Wood-to-Gas Fireplace Conversion in The Colony, TX is the project of replacing a wood-burning fireplace — or an unused/decommissioned masonry firebox — with a clean, code-compliant gas appliance. We work all four conversion paths: a vented gas log set dropped into an existing firebox (the budget-friendly entry, $800–$–+ installed), a sealed-combustion gas insert that slides into the existing masonry opening ($2,500–$–+), a brand-new direct-vent gas fireplace vented through an exterior wall ($3,800–$–+), or a full rebuild where we tear out the old chase, install a new gas fireplace, and finish the wall to your design ($6,500–$–+). Which path is right for your The Colony home depends on three things: the condition of your existing chimney, your gas-line situation, and the look you want when it’s done.
What’s specific about The Colony for wood-to-gas fireplace conversion: The Colony is largely 1980s-2000s suburban construction with prefab chimney systems. That housing pattern matters because the older masonry chimneys (anything pre-1990) usually have terra-cotta flue tiles that are fine for a vented gas log set but require a stainless-steel liner upgrade if you go with a sealed gas insert (the insert’s vent connector must terminate into a continuous metal liner, per IRC G2425 / IFGC fuel-gas code). Newer The Colony prefab-chimney homes often already have a direct-vent termination on the chase, which simplifies a swap-style insert install — but we always verify the existing chase venting is sized for the new appliance before we quote.
The gas-line side is where most The Colony conversion projects need real attention. If your home already has a gas appliance line within ~25 feet of the fireplace (a gas water heater, gas stove, or gas furnace nearby), adding a fireplace branch is typically a half-day job and adds $400-$-+ to the quote. If the fireplace is on an exterior wall with no nearby gas service — common in The Colony homes built before gas appliances were standard — we coordinate with a licensed plumber to run a new branch from the meter, which adds $900-$-+ depending on routing and the distance to The Colony’s gas main. Atmos Energy serves most of The Colony (Texas Gas Service serves a few sub-areas); the gas company itself handles meter sizing if you’re adding load that pushes you over the existing meter capacity. We pull the city-issued mechanical permit on every conversion — wood-to-gas fireplace conversion work requires permit + final inspection in every DFW jurisdiction.
What we see most often on wood-to-gas fireplace conversion jobs in The Colony: Chase-cover rust, top-mount damper sticking, prefab refractory cracks. The conversion is also the right moment to address whatever the wood-side chimney was doing — if you’ve been putting off crown work, liner deterioration, or a smoke-chamber repair, those line items can be folded into the conversion quote at substantial labor savings (we’re already there, with scaffold and access). Whether you’re in Riverwalk, Stewart Peninsula, Eastvale, or anywhere else inside The Colony city limits, we cover the full market with same-week scheduling for inspection and 1-3 week scheduling for the conversion itself (gas-line work is the longest lead-time piece).
Why this matters in DFW specifically
The Colony sits in the same DFW climate zone — short cold-weather window (typically Nov-Feb), expansive clay soil, freeze-thaw cycling on chimney crowns, and a wet-fall pattern. That climate context drives the ROI math on wood-to-gas fireplace conversion: most The Colony homeowners burn 2-4 cords of wood per season ($700-$-+/year at current DFW firewood prices) plus the required annual sweep ($249-$-+ for a Level 2 inspection">Level 2 inspection on a wood-burning system). Switching to gas drops the annual fuel bill to $80-$-+ (typical DFW use pattern), the annual maintenance cost to $149-$-+ (gas appliance check), and eliminates the creosote, the ash, and the chimney-fire risk entirely. Payback is typically 1.5-3 years on a gas log set, 3-6 years on a quality insert. The conversion also opens up summer usability — gas log sets and inserts run on demand without the ramp-up, which matches DFW’s actual fireplace use pattern (short ambience-driven sessions, not all-day burns).
Our process
- Schedule the assessment — Call or email — we confirm a The Colony appointment window typically within 24-48 hours. Inspection is free; we evaluate firebox condition, flue/liner condition, gas-line proximity, venting options, and your design preferences.
- On-site evaluation — Trained tech inspects the existing chimney/firebox, measures opening dimensions, locates the nearest gas service, and walks all four conversion paths with you (gas log set, insert, direct-vent, full rebuild). We bring photos of finished work in The Colony-area homes for reference.
- Written quote with appliance options — Fixed-price scope in writing within 2-3 business days, with 2-3 appliance options at different price points. We quote the conversion as one all-in number — gas line work, permit, appliance, install, finish work, and final inspection are all bundled. No surprise add-ons.
- Permit + gas-line preparation — We pull the The Colony mechanical permit (and the gas-line permit if a new branch is required) before scheduling the install. Gas-line work is coordinated with our licensed plumbing partner — typically a 4-8 hour job that’s done 1-2 days ahead of the appliance install.
- Conversion install (1-2 days typical) — Wood-to-Gas Fireplace Conversion performed to NFPA 211, IRC G2425 (fuel gas), and CSIA standards by trained technicians. Containment plastic protects the rest of your home; old wood-burning components are removed cleanly; the new appliance is connected, leak-tested, and fired.
- Final inspection + handover — The Colony mechanical inspector signs off the install (we coordinate the appointment). You get manufacturer warranty paperwork (typically 5-10 years on the appliance, lifetime on the install workmanship), operating instructions, and a maintenance schedule. Before/after photos delivered same-day.
Materials and standards
All wood-to-gas fireplace conversion work in The Colony follows IRC G2425 (International Residential Code, fuel-gas chapter), IFGC (International Fuel Gas Code), NFPA 211 (chimneys, fireplaces, and vents), and CSIA (Chimney Safety Institute of America) protocols. Appliances we install are CSA / ANSI Z21.50 listed (sealed-combustion gas fireplaces) or ANSI Z21.60 listed (vented gas log sets). Our technicians carry general liability + workers’ comp insurance. Permit + final inspection are pulled in every The Colony job — no exceptions.
Pricing ranges (DFW, 2026)
Real DFW market ranges. Your actual quote depends on access, scope, and what we find on inspection — every job is quoted in writing before work begins.
| Service | Typical Range |
|---|---|
| Gas log set (vented, drop into existing firebox) | $800– $– + |
| Gas fireplace insert (sealed combustion, into existing masonry) | $2,500– $– + |
| Direct-vent gas fireplace (new sealed unit, vented through wall) | $3,800– $– + |
| Full rebuild — gas fireplace + new chase/finish | $6,500– $– + |
| Gas line branch from nearby existing line (typical) | $400– $– + |
| New gas line run from meter (longer routing) | $900– $– + |
| The Colony permit + final inspection | $85– $– + (passed-through) |
| The Colony additional / custom finish work | Quoted after on-site assessment |
| ─── ROI vs. continuing wood-burning ─── | ─── annual cost comparison ─── |
| Annual wood ($350-$-+/cord, 2-4 cords typical) | $700– $– + |
| Annual chimney sweep + Level 2 inspection (wood-burning) | $249– $– + |
| Annual gas appliance check + tune-up (post-conversion) | $149– $– + |
| Annual fuel cost — gas log set / insert (typical DFW use) | $80– $– + |
| Estimated annual savings after conversion (typical) | $520– $– + |
| Payback period (gas log set, low-end) | 1.5 – 3 years |
| Payback period (insert, mid-range) | 3 – 6 years |
Frequently asked questions
How long does a gas conversion">wood-to-gas conversion take in The Colony?
Total elapsed time from signed quote to working gas fireplace is typically 2-4 weeks in The Colony. The on-site work itself is short — gas-line installation is a half-day, the appliance install + connection is 1-2 days, and final inspection is a 30-minute appointment. The lead time is mostly permit processing (The Colony typically issues mechanical permits in 3-5 business days) and appliance order/delivery (1-2 weeks for in-stock units, 3-6 weeks for special-order finishes).
Do I need a permit for a wood-to-gas fireplace conversion in The Colony?
Yes — every DFW jurisdiction including The Colony requires a mechanical permit for fuel-gas appliance installation, plus a final inspection by the city. We pull both the mechanical permit and the gas-line permit (when a new line is required) as part of the project. Permit fees are passed-through at cost, typically $85-$-+ in The Colony depending on scope. Trying to skip the permit is a non-starter — your homeowners insurance won’t cover an un-permitted gas appliance fire, and resale disclosure becomes a problem.
How much does the gas line itself cost?
It depends on what’s already there. If your The Colony home has an existing gas appliance (water heater, range, furnace) within ~25 feet of the fireplace, branching a new line off costs $400-$-+ — typically a 4-hour job. If we have to run a brand-new line from the gas meter to the fireplace location, expect $900-$-+ depending on the distance and routing complexity (whether we can run through a crawl space, attic, or have to trench around the foundation). We always include the gas line cost in the bundled written quote — no surprise add-ons after work begins.
What code applies to wood-to-gas conversions in The Colony?
The Colony adopts the International Residential Code (IRC) and International Fuel Gas Code (IFGC) — the relevant section is IRC G2425 (chimneys and vents serving gas appliances). Combustion air, vent sizing, clearance to combustibles, gas-line sizing, and shutoff valve placement are all code-specified. We also follow NFPA 211 for the chimney/vent side and the manufacturer’s installation instructions (which are themselves code-required reading). For sealed-combustion inserts, the existing flue must be relined with a continuous stainless-steel liner sized to the appliance — code-mandated, not optional.
Can I convert back to wood-burning later if I change my mind?
Yes, but it’s not free. A vented gas log set is the most reversible option — pull the logs and the gas connection, and the original masonry firebox is intact for wood use again (you’d want a fresh Level 2 inspection before burning). A gas insert is partially reversible — the insert lifts out, but the stainless liner stays (no harm, and it’s actually an upgrade for any future wood use). A direct-vent unit and a full rebuild are not practically reversible — you’d be rebuilding the chimney from scratch. Most The Colony homeowners who convert do not regret it; the maintenance, mess, and fire-risk reduction is significant.
What warranty comes with the conversion?
Two layers. The gas appliance manufacturer warranty (5-10 years typical on the firebox/burner, 1-3 years on electronics like the remote/wall control) — registered in your name, with full transferability if you sell the home. Plus our workmanship warranty: lifetime on the install labor (gas connections, venting, framing, finish work) for as long as you own the The Colony home. If anything fails on the install side, we’re back out and we fix it at no charge.
Do you offer financing for wood-to-gas fireplace conversion in The Colony?
Yes — we partner with Sunbit and other home-improvement lenders that approve in 30 seconds with a soft credit pull (no impact on credit score for the application itself). Typical conversion projects qualify for 12-60 month terms with 0% promo APR available on shorter terms. We’ll bring the financing options to the quote conversation; no obligation either way. Most The Colony homeowners pay cash for gas log set conversions and finance inserts/direct-vent/full-rebuild projects.
Related services
Ready to schedule?
Call (214) 444-8103 for wood-to-gas fireplace conversion in the colony, tx across DFW, or use our contact form for email. Same-week scheduling for most calls.
Our Sister Companies — Specialists in Related Services
Texas Service Experts is part of a network of CSIA-certified chimney specialists. Depending on your specific need:
- Texas Service Experts — general chimney sweep/inspection
- Prime Chimney Experts — multi-state national service
Our sister brand Texas Service Experts specializes in premium fireplace remodel + chimney service. Learn more →